Bosch B426 Installation And Operation Manual page 18

18 en | Configuration
If the module fails to obtain an address from the primary server, the alternate DNS server is
used, if specified. To use the alternate address, you must specify a primary address.
IPv6 Mode
Default: Disable
Selections: Enable, Disable
Enable: IPv6 enabled; module works with both IPv6 and IPv4 addressing.
Disable: IPv6 disabled; module works only with IPv4 addressing.
IP Version 6 (IPv6) is a new version of Internet Protocol. Select whether the module works
with IPv6 in addition to IPv4 addressing.
Obtain IPv6 DNS Server Address Automatically
Default: Yes
Selection: Yes, No
Setting this parameter to No allows entering the server address. Setting this parameter to Yes
clears addresses and prevents address entry. In DHCP mode, the default value of 0.0.0.0
indicates that the DHCP server's default DNS is used. To use a custom DNS server in DHCP
mode, change the parameter to No and enter the specified DNS server's IP address.
IPv6 DNS Server IP Address
Default: ::
Selection: 0:0:0:0:0:0:0:0 to FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
This parameter configures the IPv6 DNS server address.
A DNS server converts internet domain names or hostnames to their corresponding IP
addresses. In DHCP mode, the default value indicates the DHCP server's default DNS is used.
To use a custom DNS server in DHCP mode, change the parameter to the specified DNS
server's IP address.
The IPv6 DNS address has a hexadecimal notation, which consists of the eight groups of the
address expressed separately in hexadecimal and separated by colons. Each group can have a
value between 0000-FFFF. When this is defined through the DHCP service, leave the default
value.
Alternate IPv6 DNS Server IP Address
Default: ::
Selection: 0:0:0:0:0:0:0:0 to FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
This parameter provides an alternate IPv6 DNS server IP address.
The Alternate IPv6 DNS address has a hexadecimal notation, which consists of the eight
groups of the address expressed separately in hexadecimal and separated by colons. Each
group has a value between 0000-FFFF.
When this is defined through the DHCP service, leave the default value. If the module fails to
obtain an address from the primary server, the Alternate IPv6 DNS server is used, if specified.
The module can use the Alternate IPv6 DNS server address only when the Primary address is
not the default address.
2016.08 | 08 | F.01U.266.226 Installation and Operation Guide
Conettix Ethernet Communication Module
Bosch Security Systems, Inc.