Table of Contents
Advertisement
V. Microsoft Windows NT
Video Driver Installation
Installing Video Display Drivers in Windows NT 4.0
The procedure below describes how you install ASUS S3 series display
driver for Windows NT.
1. Change Display Type to Standard VGA mode.
2. Run Windows NT Display program located in the Control Panel, under
Settings in the Start menu. Alternatively, position the cursor on the
background of the desktop, click the right mouse button, then select
Properties from the pop-up menu.
3. Select the Settings page.
4. Select Display Type...
5. Select Change... from the display options.
6. Select Have Disk...
7. Windows NT will prompt you for the correct path, enter the path of
driver in CD-ROM such as D:\NT40 (assuming your CD-ROM drive
is letter D).
8. A list of ASUS video adapters will be displayed. Select ASUS 3DP-
V375DX , then click on the OK button.
9. Windows NT will once again prompt for confirmation. All appropri-
ate files are then copied to the hard disk.
10. Select Apply in Control Panel. Restart Windows NT. Windows NT
will start up using the ASUS 3DP-V375DX driver.
11. Windows NT will boot into a default mode and start the Display applet
allowing for mode selection.
Note: You must select Standard VGA while installing Windows NT
4.0. If you use the detected S3 driver provided by Windows NT, and
press the "Test" button, the system will hang!
ASUS 3DP-V375 DX User's Manual
29
Advertisement
Table of Contents
