Panasonic AJ-YDX30G Operating Instructions Manual page 10

Formatting an SD memory card
1. Insert an SD memory card into the camera
recorder.
2. Press the THUMBNAIL button to display the
thumbnail screen.
3. Press the THUMBNAIL MENU button.
4. Select OPERATION > FORMAT > SD
CARD > YES, using the cursor buttons and
the SET button.
This completes formatting of the SD memory
card.
Approximate recording time for
proxy data recording
Recording
recording
modes
Approx.
STD 2CH MP4
1650 kbps
Approx.
LOW 2CH MOV
950 kbps
Approx.
HQ 2CH MOV
1650 kbps
Approx.
HQ 4CH MOV
1780 kbps
Approx.
SHQ 2CH MOV
5060 kbps
（Reference values when Panasonic bland SD memory
cards or SDHC memory cards are used for continuous
recording. Actual recording time depends on the kind of
scenes and the number of clips.)
E-9
Total Recording
time
rate (for 1GB)
Approx.
78 minutes
Approx.
135 minutes
Approx.
78 minutes
Approx.
72 minutes
Approx.
25 minutes
PROXY Recording in ONE CLIP REC
mode
PROXY recording is also possible in ONE CLIP
REC mode. As PROXY data is also similarly
compiled into a combined clip, the P2 viewer can
also handle this data as a single clip. However,
note the following points when recording PROXY
data to a SD memory card.
If the SD memory card is removed and
replaced while combining to the clip, the
PROXY is not recorded to the next SD
memory card until the clip stops being
combined. Check that there is sufficient space
and also the number of files (recordable up to
a maximum of 1000 clips) before use. In the
event that the SD memory card is replaced
while combining, continue recording the
PROXY by pressing and holding the STOP
button for about 2 seconds to stop combining
and to start recording to a new clip.
If the SD memory card is stopped while
recording, the PROXY data will not match the
clip data recorded to the P2 card and will be
incomplete.
The parts of PROXY setting menu are
restricted when combining to the clip. Press
and hold the STOP button for about 2 seconds
to stop combining to the clip when switching
this menu.