Philips HP8112 User Manual

Register your product and get support at
www.philips.com/welcome
HP8112
User manual
EN ID
a
b
c
Specifications are subject to change without notice
© 2015 Koninklijke Philips N.V.
All rights reserved.
3140 035 39483
English
Congratulations on your purchase, and welcome to Philips! To fully
www.philips.com/welcome.
1 Important
Read this user manual carefully before you use the appliance and keep it
for future reference.
WARNING: Do not use this appliance
near water.
When the appliance is used in a
bathroom, unplug it after use since
the proximity of water presents a risk,
even when the appliance is
switched off.
WARNING: Do not use this appliance
near bathtubs, showers, basins
or other vessels containing
water.
Always unplug the appliance after use.
If the appliance overheats, it switches
off automatically. Unplug the appliance
and let it cool down for a few minutes.
Before you switch the appliance on
again, check the grilles to make sure
d If the mains cord is damaged, you
must have it replaced by Philips, a
service centre authorised by Philips or
avoid a hazard.
This appliance can be used by
children aged from 8 years and above
and persons with reduced physical,
sensory or mental capabilities or
lack of experience and knowledge
if they have been given supervision
or instruction concerning use of
the appliance in a safe way and
understand the hazards involved.
Children shall not play with the
appliance. Cleaning and user
maintenance shall not be made by
children without supervision.
For additional protection, we advise
you to install a residual current device
(RCD) in the electrical circuit that
supplies the bathroom. This RCD
must have a rated residual operating
current not higher than 30mA. Ask
your installer for advice.
Do not insert metal objects into the
air grilles to avoid electric shock.
Never block the air grilles.
Before you connect the appliance,
ensure that the voltage indicated on
the appliance corresponds to the local
power voltage.
Do not use the appliance for any
other purpose than described in this
manual.
Do not use the appliance on
When the appliance is connected to
the power, never leave it unattended.
Never use any accessories or
parts from other manufacturers
recommend. If you use such
accessories or parts, your guarantee
becomes invalid.
Do not wind the mains cord round
the appliance.
Wait until the appliance has cooled
down before you store it.
Do not pull on the power cord after
using. Always unplug the appliance by
holding the plug.
This Philips appliance complies with all applicable standards and
Environment
Do not throw away the appliance with the normal household
point for recycling. By doing this, you help to preserve the
environment.
2 Dry your hair
1 Connect the plug to a power supply socket.
For precise drying, attach the concentrator ( ) onto the
a
hairdryer ( ).
d
To disconnect the concentrator, pull it off the hairdryer.
2 Adjust the switch ( ) to your preference.
b
Setting Temperature and speed Good for:
Fast drying
Careful drying
Gentle drying
3 Switch to to switch off the appliance.
After use:
1 Switch off the appliance and unplug it.
2 Place it on a heat-resistant surface until it cools down.
3 Clean the appliance by damp cloth.
4 Keep it in a safe and dry place, free of dust. You can also hang it with
the hanging loop ( ).
c
3 Guarantee and service
If you need information e.g. about replacement of an attachment or if
you have a problem, please visit the Philips website at www.philips.com
Consumer Care Centre in your country, go to your local Philips dealer.
4 Troubleshooting
Problem Cause Solution
The The power socket to Check the appliance is plugged
appliance which the appliance in correctly.
does not has been connected
Check the fuse for this power
work at all. may be broken.
socket in your home.
The appliance may Unplug the appliance and
have overheated and let it cool down for a few
switched itself off. minutes. Before you switch on
the appliance again, check the
grilles to make sure they are
The appliance may Ensure that the voltage
not be suitable for the indicated on the type plate of
voltage to which it has the appliance corresponds to
been connected. the local power voltage.