Motorola 9505 Series Instruction Manual page 68

If you want to...
end call that is on
hold
You may see one of the following messages:
Message
Trying
Hold
Failed
Cannot Hold
Second Call
Reconnect
Failed
Busy
Try Later
To place a call on hold, you must send a phone
flash (see "Sending a Flash" on page 68 for more
information) along with the appropriate feature
code provided by your service provider. To return to
your initial call, you must send another phone flash.
To send a phone flash, see page 68.
This feature is not available in GSM cellular mode.
Then...
M
Press until you see
Call
, and then press
The held call is disconnected, the
current call remains connected,
End Call?
and you see
Description
Your phone is attempting to switch
between the current and held call.
The attempt to hold a call was
unsuccessful.
A call is already on hold. You can
only place one call on hold.
The held call could not be made
active again.
Your phone is working on a
previous command. Wait a short
time before repeating the new
command.
End Held
O
to select.
.
Placing a Call on Hold
Cellular
Mode
(CDMA/
AMPS)
Cellular
Mode (GSM)
67