Tuning Indicator Adjustment; Adjusting The Pointer Position - Yamaha TP3323 Owner's Manual

Tp3300 series pedal timpani
Table of Contents

Advertisement

Tuning Indicator Adjustment

The tuning indicator shows where to set the pedal for each note. After tuning the instrument, you must
set each note on the indicator to its proper position.
1
After you have tuned your timpani to the lowest
note of its tonal range, make sure that the pointer
is located within 2~3 mm from the pedal-side end
of the indicator rail.
* If not, refer to "Adjusting the Pointer Position" .
2
Slide the lowest note of the indicator ("C" in the
case of a 23" timpani*) to the position where its
center line coincides with the pointer.
* "Standard Tonal Ranges for Yamaha Tim-
pani" on page 8.
3
Tune the instrument to the next higher pitch (note)
by moving the pedal, and then slide the corre-
sponding note on the rail to the respective pointer
position. Repeat for each remaining note.
Indicator Rail
Note
Pointer
l Relocating the Tuning Indicator
The timpani is shipped with a universal style tun-
ing indicator already attached however, the tun-
ing indicator can be relocated for German style
tuning.
Using the supplied hex wrench, remove the two
bolts holding the tuning indicator in place as
shown in the diagram right, then slide the bolts
through the holes on the tuning indicator from the
opposite side. In either position, make sure that
the note indicator bridge is easily viewable.
10
n Adjusting the Pointer Position
First loosen the pointer lock nut and then turn the ad-
juster as follows:
• Pointer is located beyond the lower rail end
when the heel of the pedal is lowered fully
(lowest note).
→ Turn the adjuster to the left (counter clock-
wise) until the pointer is aligned with the low-
est note of the indicator.
• Pointer moves beyond the upper rail end be-
fore the toe of the pedal reaches the end of its
stroke, or Pointer does not reach the lower rail
end when the heel of the pedal is lowered fully
(lowest sound)
→ Turn the adjuster to the right (clockwise) to
correct the pointer position as required.
Pointer Lock Nut
Universal Style
Attachment
Tuning
Indicator Bolt
Mounting Bracket
Note
Adjuster Cover
* Replace the
cover after
adjusting.
Adjuster
German Style
Attachment
Tuning
Indicator Bolt

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tp3326Tp3329Tp3332

Table of Contents