Example: Verifying the Status of DSCP-to-queue Mapping
random-detect dscp-based
random-detect dscp 4 minimum-threshold percent 20 maximum-threshold percent 40
Example: Verifying the Status of DSCP-to-queue Mapping
The following sample output from the show hardware qos dscp-to-queue ingress command displays the
status of DSCP-to-queue mapping enabled in ingress direction on M-series modules:
Switch# show hardware qos dscp-to-queue ingress
status: Enabled
module_type : m-series
Feature History for Queuing and Scheduling
The table below summarizes the new and changed features for this document and shows the releases in which
each feature is supported. Your software release might not support all the features in this document. For the
latest caveats and feature information, see the Bug Search Tool at
release notes for your software release.
Table 33: Feature History for Queuing and Scheduling
Feature Name
DSCP to Queue Mapping
DSCP to Queue Mapping
System-defined queue types
No change from Release
4.1(2)
Cisco Nexus 7000 Series NX-OS Quality of Service Configuration Guide
112
Configuring Queuing and Scheduling on M-Series I/O Modules
Release
8.0(1)
6.2(2)
6.2(2)
5.1(1)
https://tools.cisco.com/bugsearch/
Feature Information
Use the hardware qos dscp-to-queue ingress
module type f-series command to enable
dscp-to-queue mapping on M3-Series I/O
modules
This feature was introduced.
Updated the System-Defined Queue Types
table with new system-defined queue types
for 4q8q policy templates on the Cisco Nexus
7710 switch and the Cisco Nexus 7718 switch.
—
and the