Sanyo ECR 160 Instruction Manual page 7

§
Amount tendered & Cash key
[%+]
%+ key (% mode)
Index the amount tendered by the customer via This key following entry is used to register a
this key. The register automatically displays the manual percentage mark up.
A
correct change and opens the cash drawer. If this Without previous entry this key is used to
(
key is depressed without any previous entry, the calculate and register a mark-up according to
transaction is finalized and a receipt is issued.
preset percentage.
~
Department key
~
%-key (%mode)
Index an amount first, then depress appropriate This key following entry is used to register a
department key for itemizing. In tax mode each manual percentage discount.
department key may be set individually for Without previous entry this key is used for
[o~n
taxable or non-taxable status. Also department 2 discount calculation according to preset percent-
can be programmed as a discount department.
age.
Entry digit limit and single-item/non single-item
can be programmed by department. GiJ
Half
pence key (U.K. mode)
Used to enter a half pence.
~
Tax shift key (Tax mode)
This key, followed by a department key, causes
[!]
Paper feed key
a temporary shift from a preset taxable depart- Used to feed the tape forward.
ment to a non-taxable department or vice versa.
Depressing this key immediately before a tender-
ing key makes a transaction exempt from a tax.
RECEIPT
Journal/Receipt selection
[~~9] Manual tax
&
Taxable subtotal key (Tax mode)
OFF~
ON
switch
By turning this switch on, the
This key after amount entries is used to register
tape is automatically fed to
(
a manual tax. In this case the preset tax will be
the cutting position.
cancelled.
Without a previous entry this key is used to
obtain a taxable subtotal.
-5