Siemens CDC-4 Installation Instructions Manual page 3

PRE-INSTALLATION
HUNDREDS
TENS
ONES
HNET
Siemens Industry, Inc.
Building Technologies Division
ZONE 2 TROUBLE
ZONE 2 CLASS A OPEN
ZONE 3 ALARM
ZONE 3 TROUBLE
ZONE 3 CLASS A OPEN
ZONE 4 ALARM
ZONE 4 TROUBLE
ZONE 4 CLASS A OPEN
Three rotary dial switches at the bottom of the front panel are used to set the HNET
network address of the CDC-4.
The network address switches must be set prior to inserting the card into the CC-5
(refer to Figure 1):
Network Address Switches: Set the three-digit HNET network address for the
CDC-4 using the three rotary dial address switches located near the bottom of the
front panel. (Refer to Figure 1 for the location of the switches.) The address for the
CDC-4 must be the same as the address selected for it in the Zeus Programming
Tool. To set the address, turn the pointers on each of the three dials to the numbers
for the selected address. For example, if the address is 123, set the pointer for the
HUNDREDS dial to "1" , set the pointer for the TENS dials to "2" , and set the pointer
for the the ONES dial to "3" . The range of allowable addresses is from 001 to 251
(leading zeros must be used).
(Yellow) Normally OFF . When illuminated, indicates
that a trouble condition has been de-
tected in Zone 2. It will stay on continu-
ously until the condition is cleared.
(Yellow) Normally OFF . When illuminated, indi-
cates that there is a break in the Class A
wiring in Zone 2.
(Red) Normally OFF . When illuminated indi-
cates that an alarm condition has been
detected in Zone 3. It will stay on
continuously until the system is reset.
(Yellow) Normally OFF . When illuminated, indicates
that a trouble condition has been de-
tected in Zone 3. It will stay on continu-
ously until the condition is cleared.
(Yellow) Normally OFF . When illuminated, indi-
cates that there is a break in the Class A
wiring in Zone 3.
(Red) Normally OFF . When illuminated indi-
cates that an alarm condition has been
detected in Zone 4. It will stay on
continuously until the system is reset.
(Yellow) Normally OFF . When illuminated, indicates
that a trouble condition has been de-
tected in Zone 4. It will stay on continu-
ously until the condition is cleared.
(Yellow) Normally OFF . When illuminated, indi-
cates that there is a break in the Class A
wiring in Zone 4.
3 P/N 315-034200-9