DeWalt DXST4500 Instruction Manual page 10

Titan industrial rack 4-foot tall / 3-shelf

Hide thumbs Also See for DXST4500:

DXST4500

SHELF SUPPORT AND SAFETY STRAP INSTRUCTIONS

•

Note: There are two (2) Safety Straps with Weld Nuts and

three (3) Shelf Support Straps for every set of crossbeams.

STEP 1

•

Starting with the lowest set of crossbeams, place a Safety

Strap with Weld Nut between the lower ridges of the

crossbeams where two sets of holes have been pre-drilled.

Thread a Safety Strap Bolt up through the bottom of the

pre-drilled holes and through the Weld Nuts, and fully

tighten with the included hex key or drill bit. Repeat for the

second strap on this set of crossbeams, and continue for

the last four straps.

STEP 2

•

Place a Shelf Support Strap perpendicular to the

crossbeams, and insert each end into the slots on each

ridge of the crossbeam. Repeat for the remaining eight

straps.

Table of Contents

Show Quick Links