Philips NTX400 Short User Manual

Always there to help you
Register your product and get support at
www.philips.com/support
Question?
Contact
Philips
Short User Manual
Specifications are subject to change without notice.
2015 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is sold under the responsibility of Gibson Innovations Ltd., and
Gibson Innovations Ltd. is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V. and are used
under license from Koninklijke Philips N.V.
NTX400_79_SUM_V1.0
Safety
To establish a safe volume level:
• Set your volume control at a low setting.
•
Slowly increase the sound until you can hear it comfortably
and clearly, without distortion.
Know these safety symbols
Listen for reasonable periods of time:
• Prolonged exposure to sound, even at normally 'safe' levels, can
also cause hearing loss.
• Be sure to use your equipment reasonably and take
appropriate breaks.
Be sure to observe the following guidelines when using your
headphones.
• Listen at reasonable volumes for reasonable periods of time.
This 'bolt of lightning' indicates uninsulated material within your unit
•
Be careful not to adjust the volume as your hearing adapts.
may cause an electrical shock. For the safety of everyone in your
• Do not turn up the volume so high that you can't hear what's
household, please do not remove product covering.
around you.
The 'exclamation point' calls attention to features for which you
• You should use caution or temporarily discontinue use in
should read the enclosed literature closely to prevent operating and
potentially hazardous situations.
maintenance problems.
Note
liquids, such as vases, should not be placed on this apparatus.
•
The type plate is located on the back of the unit.
CAUTION: To prevent electric shock, match wide blade of plug to
wide slot, fully insert.
Notice
Warning
•
Never remove the casing of this device.
expressly approved by Gibson Innovations may void the user's
•
Never lubricate any part of this device.
authority to operate the equipment.
•
Never place this device on other electrical equipment.
•
Disposal of your old product
• Never look into the laser beam inside this device.
•
Ensure that you always have easy access to the power cord, plug, or
adaptor to disconnect this device from the power.
Your product is designed and manufactured with high
quality materials and components, which can be recycled
and reused.
•
Do not use this apparatus near water.
Do not throw away the product with the normal
• Install in accordance with the manufacturer's instructions.
household waste at the end of its life, but hand it in at
•
Do not install near any heat sources such as radiators, heat
preserve the environment.
produce heat.
• Protect the power cord from being walked on or pinched, Environmental information
particularly at plugs, convenience receptacles, and the point All unnecessary packaging has been omitted. We have tried to
where they exit from the apparatus. make the packaging easy to separate into three materials: cardboard
•
• Use only with the cart, stand, tripod, bracket, or
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
the apparatus. When a cart is used, use caution
regulations regarding the disposal of packaging materials, exhausted
when moving the cart/apparatus combination to
batteries and old equipment.
avoid injury from tip-over.
•
Unplug this apparatus during lightning storms or when unused
Trademark notice
for long periods of time.
•
The Bluetooth® word mark and logos are
required when the apparatus has been damaged in any way,
registered trademarks owned by Bluetooth
such as power-supply cord or plug is damaged, liquid has been
SIG, Inc. and any use of such marks by Gibson
spilled or objects have fallen into the apparatus, the apparatus
is under license. Other trademarks and trade names are those of
has been exposed to rain or moisture, does not operate
their respective owners.
normally, or has been dropped.
•
Battery usage CAUTION – To prevent battery leakage which The N Mark is a trademark or registered
may result in bodily injury, property damage, or damage to the
trademark of NFC Forum, Inc. in the
remote control: United States and in other countries.
• Install the battery correctly, + and - as marked on the
This is CLASS II apparatus with double insulation, and no
remote control.
protective earth provided.
• Do not mix batteries (old and new or carbon and
The making of unauthorized copies
• Remove the battery when the remote control is not
of copy-protected material, including
used for a long time.
• The battery shall not be exposed to excessive heat such as
and sound recordings, may be an
infringement of copyrights and constitute a criminal offence. This
• Apparatus shall not be exposed to dripping or splashing.
• equipment should not be used for such purposes.
Do not place any sources of danger on the apparatus (e.g.
• Where the MAINS plug or an appliance coupler is used as the
the right to change products at any time without being obliged to
disconnect device, the disconnect device shall remain readily
operable. adjust earlier supplies accordingly.
Caution
•
Use of controls or adjustments or performance of procedures other than
herein may result in hazardous laser exposure or other unsafe operation.
Hearing safety
Listen at a moderate volume.
• Using headphones at a high volume can impair
your hearing. This product can produce sounds
in decibel ranges that may cause hearing loss
for a normal person, even for exposure less
than a minute. The higher decibel ranges are
offered for those that may have already experienced some
hearing loss.
•
Sound can be deceiving. Over time your hearing 'comfort
level' adapts to higher volumes of sound. So after prolonged
listening, what sounds 'normal' can actually be loud and harmful
to your hearing. To guard against this, set your volume to a safe
level before your hearing adapts and leave it there.
NTX400_79_SUM_V1.0.indd 1
NTX400
To download the full user manual, visit
www.philips.com/support.
Connect FM antenna
Wireless & networks
NFC
NFC
BT BT connected
DISC
Before connecting to AC power, adjust the voltage
selector to match your local power supply.
Connect AM antenna
Play from a NFC compatible device
1
Enable the NFC feature on your Bluetooth device.
2
Tap the NFC tag on the top of the product with the NFC area of your
Bluetooth device until you hear a beep.
3
On your Bluetooth device, accept the pairing request with "Philips NX4".
4
Follow the on-screen instructions to complete the pairing and connection.
5
Play audio on the device.
Audio streams from your device to this product.
»
Play from other Bluetooth devices
1
Press SOURCE repeatedly to select the [BT] source.
2
On your Bluetooth device, enable Bluetooth and search for Bluetooth
devices.
3
Select [Philips NX4] displayed on your device for pairing.
After successful connection, [BT connected]
»
on the screen, and the product beeps twice.
4
Play audio on the device.
» Audio streams from your device to this product.
Note:
•
Any obstacle between this product and a Bluetooth device can reduce the
operational range.
•
Before connecting another Bluetooth device, disconnect the current device
Philips NX4
USB
Always there to help you
Register your product and get support at
www.philips.com/welcome
Question?
Contact
Philips
Short User Manual
Turn on Standby
Standby Eco Power Standby
Button Function
Press to skip to the previous or next
/
track.
Press and hold to fast forward or fast
reverse the track during playback,
then release to resume play.
Press to select an album.
/
Press to pause or resume play.
Press to stop play or erase the
programmed list.
PROG Program the play sequence of tracks.
MODE Press repeatedly to select:
[OFF]: return to normal play.
[REPEAT ONE]: play the current
track repeatedly.
[REPEAT ALL]: play all tracks
repeatedly.
[SHUFFLE]: play all tracks randomly.
7/29/2015 4:19:23 PM