Assembly - Husqvarna 135 Mark II Operator's Manual

and replacement parts as recommended. Do not
change your product.
• Keep the saw chain sharp and clean for safe and
high performance.
• Obey the instructions for lubricating and changing
accessories.
• Examine the product for damaged parts. Before
more use of the product, make sure the damaged
guard or part operates correctly. Examine for broken
or incorrectly aligned parts, and parts that do not
move freely. Examine for other conditions that can
have an effect on the operation of the product. Make
WARNING: Read and understand the safety
chapter before you assemble the product.
To assemble the guide bar and saw
chain
1. Remove the spark plug cap from the spark plug
during assembly to prevent an accidental start.
2. Remove the bar nuts and the clutch cover. Remove
the transportation guard (A).
3. Put the guide bar above the bar bolts. Steer the
guide bar to its most rear position.
4. Put on protective chainsaw gloves.
10
sure the product is correctly installed. A guard or
other damaged part must be repaired or replaced by
an approved dealer unless written in the operator's
manual.
• When not in operation, keep the product in a dry,
high or locked area away from children.
• During transportation or storage of the product, use
a guide bar cover or case to move the product.
• Do not use waste oil. Waste oil can be dangerous to
you and can cause damage to the product and
environment.

ASSEMBLY

5. Lift the saw chain above the drive sprocket and
engage it in the groove on the guide bar. Start on the
top edge of the guide bar.
6. Make sure that the edges of the cutting links are
turned forward on the top edge of the guide bar.
7. Assemble the clutch cover and steer the chain
adjuster pin to the hole in the guide bar.
8. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket. Also make sure that
the saw chain is correctly engaged in the groove in
the guide bar.
9. Tighten the guide bar nuts finger.
862 - 001 - 20.09.2018