Advertisement
Possible lamps to be used are...
Aluminum/Brass Fixtures:
Wattage
250W MAX
300W MAX
150W MAX
150W MAX
Composite Fixtures:
Wattage
175W MAX
150W MAX
100W MAX
100W MAX
* AN OPEN RATED LAMP MUST BE USED WHEN NOT USING SHROUD.
INSTALLATION INSTRUCTIONS
1. Make sure power is OFF before installing or servicing this fiixture.
2. The fixture must be mounted to a U.L. listed junction box or mounting stake. Stake #S3 & S35
may be used, or boxes #M0029, BI1, BI2, BI3, BI4, CB1, TM2H, TMC2H, or any IBH/WBH ballast boxes.
3. Thread wires through hole in stake cap, or junction box lid. Screw arm of fixture onto lid.
Lock into desired position by tightening arm locknut.
4. Connect white supply wire to white fixture wire, black supply wire to black fixture wire, and supply
ground wire to fixture ground wire. Use wire connectors (not supplied) to secure connections.
5. Attach cap/lid to stake/box, making sure not to pinch wires.
6. If fixture includes a shroud, loosen the shroud screw and remove the shroud.
7. Install specified lamp according to lamp label on fixture and/or the chart above.
8. If using a Metal Halide lamp, fill in the lamp wattage and ANSI Code on the lamp label. The lamp and
ballast ANSI codes must match (see below chart of Hadco ballasts and ANSI Codes).
9. If shroud was included, or purchased separately, put shroud on fixture and tighten shroud screw.
HADCO BALLAST TABLE (INFO TO BE USED TO COMPLETE HID LAMP LABEL)
32000562, revision G
Lamping
PAR38 INCANDESCENT
R40 INCANDESCENT
PAR38 MH
E17 MH
Lamping
PAR38 INCANDESCENT
R40 INCANDESCENT
PAR38 MH
E17 MH
Model Number
ABH/IBH/WBH
ABH/IBH/WBH
ABH/IBH/WBH
ABH/IBH/WBH
ABH/IBH
Reflector
NO
NO
NO
YES
Reflector
NO
NO
NO
YES
Wattage
ANSI Code
35
M130
50
M110
70
M98/M143
100
M90/M140
150
M102/M142
Shroud
OPTIONAL
REQUIRED
REQUIRED
INCLUDED
Shroud
OPTIONAL
REQUIRED
REQUIRED
INCLUDED
page 2 of 3
Advertisement
