Table of Contents
Advertisement
Screen with Map
• Remove Via : Removes the 'via point' near or at the Cursor.
The route will be recalculated immediately excluding the deleted
point. This menu point replaces Add Via and is available only if the
Cursor is near or at a via point.
• Start : Use the Cursor as the departure point for your route.
This menu point is available only in Map mode and when there is
no active route. The departure point of the route is always the
GPS position or if it is not available, the last known GPS position.
• Route To : Use the Cursor as the destination of your route.
This button is to start a new route. The previous route (if it exists)
will be deleted and replaced. If a multi-point route is active, the
navigator will ask you whether you really want to delete it together
with all its via points.
• Add Via : By inserting the selected map point as a via, you
instruct the navigator to cross this location before the destination
of the route.
This is the way to build a multi-point route in reverse order (when
you wish to insert a stopover 'go to A but first get some fuel at B'
or want to influence the direction of the route). This menu point
works only if a route is already active.
• Continue : Add a new destination to be reached after the previous
destination.
The new destination replaces the old one, which is now demoted
to a via point. This is the way to build your multi-point route in
straight order (when you wish to visit several destinations 'go to A
then to B'). This menu point is available only if a route is already
active.
• Pin : The Cursor can be marked with a Pin.
30
Advertisement
Table of Contents
