Related Manuals for Samsung RF28NH Series
Summary of Contents for Samsung RF28NH Series
-
Page 1: Installation Guide
Refrigerator Installation Guide Free Standing Appliance Untitled-3 1 2018-04-10 12:31:22... - Page 2 Installation Follow these instructions carefully to prevent accidents and to ensure the proper installation of this refrigerator. WARNING • Use the refrigerator only for its intended purpose as described in this manual. • Any servicing must be performed by a qualified technician. •...
- Page 3 • When the door is opened, the interlock switch automatically disables the auger motor of the ice maker for safety reasons. • If the internal or external LED lamp is out of order, contact a local Samsung service center. English 15...
- Page 4 Installation Step-by-step installation STEP 1 Select a site The site must: • Have a solid level surface without carpeting or flooring that may obstruct ventilation • Be out of direct sunlight • Have adequate room for opening and closing the door •...
- Page 5 Model RF28NH* RF22NP* 2" (50 mm) 2" (50 mm) 125° 125° " " (1578 mm) (1578 mm) " " (335 mm) (335 mm) " " (908 mm) (908 mm) " 24" (610 mm) (748 mm) " " (122 mm) (122 mm) "...
- Page 6 Installation STEP 2 Flooring • The surface of the installation location must support a fully loaded refrigerator. • To protect the floor, put a large piece of cardboard under each leg of the refrigerator when you move it for installation. •...
- Page 7 STEP 3 Door removal for entrance If the refrigerator cannot pass through the entrance to your home or kitchen due to its size, follow these instructions to remove and then re-install the refrigerator's doors. If you do not need to remove the doors, go to page 16 for the installation instructions. Tools required (not provided) Phillips screwdriver Flat-heat screwdriver...
- Page 8 Installation 2. Disconnect the wire connectors (x3) and the water tube (dispenser-featured models only) from the coupler on the left door. NOTE • The position of the connectors differs with the model. • Non-dispenser models do not come with the water tube. CAUTION •...
- Page 9 5. Open the door 90 degrees. While holding the door, pull up and remove the top hinge. Be careful not to damage the connector wires when you remove the hinge. 6. Gently pull up the door vertically to remove. Do not apply excessive force to the door.
- Page 10 Installation 2. Gently draw up the clamp in several steps. To prevent finger injuries, do not apply a sudden force to the clamp. 3. Pull up the clamp to remove it. 4. Open the door 90 degrees. While holding the door, pull up and remove the top hinge.
- Page 11 5. Gently pull up the door vertically to remove. Do not apply excessive force to the door. The door may fall, causing physical injury. 6. Lay the door down on a flat surface. To reattach the fridge doors Once the refrigerator is in or near it's final location, re-attach the doors by following the directions in the reverse order of removal.
- Page 12 Installation Detach the FlexZone™ drawer 1. Lift up to remove the FlexZone™ basket. 2. Remove the wire cover along with the connector harness using a flat-head screwdriver. 3. Press the locking tab to disconnect the wire connector. CAUTION When relocking the tab, make sure to fully connect the wire connector.
- Page 13 5. Lift up to remove the drawer front of the FlexZone™ from the rail assembly. CAUTION • Use caution when removing the rail assembly, which may fall off causing damage to the floor. • Make sure to put the FlexZone™ drawer in place after removing or mounting the FlexZone™...
- Page 14 Installation To detach the freezer drawer 1. Push the upper basket to the end, and then pull up to remove. 2. Lift up to remove the door bin. 3. Then, pull up to remove the lower basket from the rail assembly. 4.
- Page 15 5. While holding the upper area of the freezer drawer front, slide the drawer out all the way to remove the freezer drawer from the rail assembly. CAUTION • Use caution not to scratch or dent the rail assembly. • Make sure you mount the freezer baskets in the correct position.
- Page 16 Installation STEP 4 Adjust the levelling feet CAUTION • When installed, the refrigerator must be leveled on a flat, solid floor. Not leveling the refrigerator can cause damage to the refrigerator or physical injury. • Levelling must be performed with the refrigerator empty. Make sure no food items are inside the refrigerator.
- Page 17 STEP 5 Adjust the door height The height of a door can be adjusted using the provided snap rings, which come in 4 different sizes (1 mm, 1.5 mm, 2 mm, and 2.5 mm). 1. Check the height difference between the doors, and then raise and hold the lower door.
- Page 18 Installation STEP 6 Attach the handles CAUTION The refrigerator handles must be oriented in the correct direction. • The fridge handles must be attached so that the holes on each face each other. • The freezer handle must be attached so that its hole faces downwards.
- Page 19 4. Insert the supplied wrench into the handle hole, and then turn it clockwise to tighten. 5. Repeat Steps 2 through 4 with the second refrigerator door handle. 6. To fix the freezer handle to the refrigerator, first place the left side of the freezer handle onto the left handle screw.
- Page 20 Installation STEP 7 Connect the water dispenser line (applicable models only) A water dispenser with a filter is one of the helpful features on your new refrigerator. To help promote better health, the water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms.
- Page 21 Connect the water supply line to the refrigerator There are several items you must purchase to complete this connection. You may find these items sold as a kit at your local hardware store. • ” copper tubing Copper Tubing • ”...
- Page 22 Installation CAUTION If you use plastic tubing, (A) do not use it without the molded end (Bulb). 2. Tighten the compression nut (B) onto the compression fitting. Do not over-tighten the compression nut (B). 3. Turn the water on and check for any leakage. If you find water drops or leakage in the connection areas, turn off the main water supply.