Condition Check Commands And Response - Sanyo PJ MASTER POA-PJNM01 Owner's Manual

Chapter 4 Advanced setting
50

Condition check commands and response

Command name Command
Power status check CR0 or CR STATUS
Lamp status check
CR LAMPSTS
Input source CR SOURCE
Input status CR SIGNAL
Input Select
CR INPUT
Temperature
CR TEMP
Lamp use time CR LAMPH
Projector use time CR PROJH
Network board ver-
LR PJNETVERSION version number
sion
Model Name CR MODELNM
* Some kinds of commands may not effective or may differ depending on each model. For further infor-
mation, please contact your sales dealer.
Response Description
00 Power on
80 Stand-by
40 Count down
20 Cooling
Lamp On, only available for multiple lamps
00
model.
80, 40,20,10 Lamp off
ANALOG Analog input
DIGITAL Digital input
S-VIDEO S-video input
VIDEO Video input
ON Signal exists
OFF No signal
1,2,3,4,5 Selected input mode
temperature Actual temperature
time Lamp use time in hours
time Accumulated use time in hours
Firmware version of network board
model name Model name,"PLC-XF60" etc.