Advertisement
Quick Links
LCD PROJECTOR LENS
MODEL NO. LNS-W01Z / LNS-T01Z
LENS REPLACEMENT
AND INSTALLATION PROCEDURES
NOTES ON REPLACEMENT AND INSTALLATION
The procedures and the needed pars for lens installation depend on the type of
cabinet. Before installing or replacing the lens, make sure the type of cabinet and be
sure to refer to the Installation Manual corresponding with your projector.
When installing or replacing the lens, make sure the Lens Model No. matches with
your projector. Refer to the catalog, or contact your sales dealer for the proper Lens
Model No.
TYPE OF THE CABINET AND REFERENCE INSTALLATION MANUAL
Refer to the Installation Manual corresponding to your projector.
(See the chart below.)
Type of the Cabinet
Other than the above cabinet
design.
Reference Installation Manual
Refer to this manual.
Refer to the Installation Manual
supplied with the Projector.
Advertisement
Related Manuals for Sanyo LNS-T01Z
Summary of Contents for Sanyo LNS-T01Z
- Page 1 LCD PROJECTOR LENS MODEL NO. LNS-W01Z / LNS-T01Z LENS REPLACEMENT AND INSTALLATION PROCEDURES NOTES ON REPLACEMENT AND INSTALLATION The procedures and the needed pars for lens installation depend on the type of cabinet. Before installing or replacing the lens, make sure the type of cabinet and be sure to refer to the Installation Manual corresponding with your projector.
- Page 2 NOTES ON LENS INSTALLATION The ZOOM and FOCUS adjustment on the Top Control or the Remote Control can- not be operated with this Lens. • Lens installation and replacement should be made by the qualified service per- sonnel. • Be sure to install the lens following this procedure precisely. •...
- Page 3 LENS REPLACEMENT AND INSTALLATION PROCEDURE Perform the steps REMOVE THE LENS COVER. (See figure-1) 1. Remove screws A (2 screws). 2. Pull down the lower lens cover while pushing the part D, then remove it. 3. Remove screws B (2 screws). 4.
- Page 4 INSTALL THE LENS. (See figure-4) 1. Remove protective caps(front and back) on the lens. 2. Mount the lens on mounting bracket of the main cabinet with 4 screws. Use the screws included with the lens. Use the driver included with the lens to fasten the screws.