Joystick Setup (Joystick) - Sanyo VSP-9000 Instruction Manual

Setup (CONFIGURATION)
• 4–Matrix alarm: Matrix alarm
detection
This setting sounds a buzzer when an
alarm is detected.
Selections: YES, NO
• 5–Power saving: Power save
function
When no buttons are operated for
approximately one minute, the screen
brightness is automatically switched
(dimmed).
When another button operation is
performed, the brightness returns to
normal.
Selections: YES, NO
3
Press the ent
The selection item stops flashing, and the
setup is complete.
b b b b Joystick Setup (JOYSTICK)
1
Press the
button to select "JOYSTICK",
then press the
The "3–JOYSTICK" screen is displayed.
button.
button or
ent button.
esc
ent
2
Press the
button to switch the joystick
setting position.
Setting positions:
Set in sequence, from number 1.
Each joystick position will be placed in
memory.
• 1–Released (Setting center position)
ent
Press the
touching the joystick.
• 2–All at right
(Setting far right position)
ent
Press the
tipped to the far right.
• 3–All at left (Setting far left position)
ent
Press the
tipped to the far left.
• 4–All up (Setting topmost position)
ent
Press the
tipped to the topmost position.
• 5–All down
(Setting bottommost position)
ent
Press the
tipped to the bottommost position.
• 6–Rotate zoom at left
(Setting left zoom position)
ent
Press the
rotated to the far left.
• 7–Rotate zoom at right
(Setting right zoom position)
ent
Press the
rotated to the far right.
When the wrong position was set
by mistake, move the cursor to the
mistaken setting and set it again.
System Setup
button or
button without
button with the joystick
button with the joystick
button with the joystick
button with the joystick
button with the joystick
button with the joystick
54