Error Information - Sanyo POA-PN03C Owner's Manual

Chapter 5 Network Capture

Error information

Error messages
Set up the parameter.
It has not been registered to PJ
as a group.
Cannot be displayed as PJ is
under display.
Cannot connect to PJ.
Cannot transfer data to PJ.
Cannot receive data from PJ.
Other PC has authority.
Cannot complete "Network
Communication".
Other PC has authority. Cannot
obtain authority.
The server name or address
could not be resolved.
Invalid port number
PJ has not started Network
Communication. Close the window
and open it again.

Cause and corresponding
Error when executing the communication. The parameter setting
(host name, capture port) has not been set.
➔ Check parameter setting (+p.71)
Error when executing Start Communication or Start real time cap-
ture. The IP address of the computer has not been registered.
➔ Register the IP address by using the web browser (+p.78)
Error when executing Start Communication or Start real time cap-
ture. The other capture, viewer or advanced card imager function
is now operating.
➔ Wait until the communication function is available.
Cannot establish the connection with the network unit when
executing the Start communication, End communication, Capture
transfer, Start real time capture or End real time capture.
➔ Check connection of the network cable.
Cannot transfer the data to the network unit when executing the
Start Communication, End Communication, Capture transfer, Start
real time capture or End real time capture. The time out period is
10 seconds.
➔ Check connection of the network cable.
Cannot receive the data from the network unit when executing
the Start Communication, End Communication, Capture transfer,
Start real time capture or End real time capture. The time out
period is 10 seconds.
➔ Check connection of the network cable.
When executing the End communication, you cannot quit the
communication because other computer has an authority
Other computer has an authority.
When setting the parameter, the computer cannot find the set-
ting host name or IP address in the network.
➔ Use available host name or IP address.
When setting the parameter, the reserved port number is speci-
fied.
➔ Check parameter setting (+p.71)
The projector might have turned off during the communication.
➔ Check projector power and restart executing "Start communica-
tion".