Turn Off The Lcd Projection Tv - Sanyo PLV-65WHD1 Owner's Manual

TURN OFF THE LCD PROJECTION TV

7
• Press the POWER key on the front panel of the LCD
Projection TV or on the remote control.
The POWER indicator becomes orange and it
continues while the cooling fans are running (for about
four minutes). The LCD Projection TV can be turned
on again during this period or after the indicator is
turned off.
• When the LCD Projection TV has cooled down
enough, the POWER indicator will be turned off. Then
you can unplug the AC power cord.
TO MAINTAIN THE LIFE OF THE LAMP, ONCE
YOU TURN YOUR LCD PROJECTION TV ON,
WAIT AT LEAST FIVE MINUTES BEFORE
TURNING IT OFF.
DO NOT UNPLUG THE AC POWER CORD
WHILE THE COOLING FANS ARE RUNNING
OR BEFORE THE POWER INDICATOR
BECOMES RED. OTHERWISE IT WILL RESULT
IN SHORTENING OF THE LAMP LIFE.
Notes:
When the lamp did not turn on properly, the LCD Projection
TV will automatically start operating the cooling fans. In this
period, the POWER indicator will flash red and cannot be
turned on.
Do not use the LCD Projection TV continuously without rest.
Continuous use may result in shortening the lamp life.Turn
off the LCD Projection TV and rest it for about an hour in
every 24 hours.
This LCD Projection TV monitors internal temperature and
automatically controls the rotating speed of the cooling fans.
If the WARNING indicator flashes red or becomes red, see
"Warning Indicator" on page 30.
Operational Tip for Monitor Use:
If the LCD Projection TV is used as a monitor only, with
a DVD player or some other type of external equipment,
and no cable or antenna signal is available, the following
setup is necessary:
Your LCD Projection TV is designed to automatically
search for available channels. Therefore, the initial start
up requires that you press the Channel (CH) ▲ key,
enabling the LCD Projection TV to automatically go
through the channel search process before you can
operate the LCD Projection TV.
10
FRONT PANEL
POWER POWER
POWER indicator POWER key
REMOTE CONTROL
INPUT
POWER
1 2 3
POWER key
4 5 6
After the initial channel search is completed, you must
press the Channel (CH) ▲ key again to complete the
channel search process. This may take several minutes.
After the channel search process is complete (2
searches), you can press the INPUT key on the remote
control to use the LCD Projection TV as a monitor.
LAMP
WARNING
REPLACE