Installation Procedure - Pioneer PDK-5011 Operating Instructions Manual

7 Installation procedure

1
Remove the special screws (2 locations) from the bot-
tom of the hung on wall unit.
Special screws (M6)
2
Remove the hardware on the wall side and the hard-
ware on the PDP side.
PDP side hardware
3
Attach the PDP side hardware to the plasma display.
Warning
• Cover the display with a sheet or similar protective material
to protect it from scratches or other damage.
• Be sure to attach it on top of a flat table or similar surface.
Plasma display
Top side of plasma display
Wall side hardware
PDP side hardware
4
Fix the plasma display to the PDP side hardware with
bolt M8 (6 locations). Be sure to use the holes marked
with the red triangle "%".
Top side of plasma display
5
Attach the wall side hardware to the wall.
Install the wall side hardware (4 locations) symmetri-
cally on the left and right side (one at each location
from the center of the
and bolts used to do this are different according to
the wall strength and wall material, purchase suit-
able screws and bolts separately.
Warning
Check the strength of the wall and beams before installing the
display.
6
Attach the hook on the PDP side hardware to the
wall side hardware.
Hook
). Because the screws
7
En