Rating Label - Hitachi PC-KCB120 User Manual

1.4 LED color and Biometric Reader status
The indicator LED shows the status of the Biometric Reader. Depending on its color and
blinking state, please take an appropriate action. Note that Hitachi Finger Vein Biometric PKI
Middleware (C-N1719-11) (hereafter called the Middleware) needs to be installed in the PC.
LED status Biometric Reader status
Biometric Reader is not connected to the
Off PC or Biometric Reader is not
recognized by the Middleware.
Biometric Reader is connected to the PC
and is recognized by the Middleware.
Orange
(Smart Card is not inserted or
recognized.)
Biometric Reader is connected to the PC
Orange blink
and Smart Card being is accessed.
Biometric Reader is connected to the PC
Green and Smart Card is recognized.
Biometric Reader is to ready for use.
Biometric Reader is connected to the PC
Green blink and is requesting the capturing of finger
vein.
Biometric Reader is connected to the PC
Red
and finger vein authentication failed.
Biometric Reader is connected to the PC
Red blink
and a device error occurred.
Note: In some PCs the LED doesn't become OFF when the PC enter SLEEP or POWER OFF.

1.5 Rating Label

2. Installation of the Biometric Reader
Action
Connect the Biometric Reader to
the PC. Install the Middleware.
Insert a supported Smart Card to
the Biometric Reader.
Wait until the LED status
becomes Green.
Do not disconnect the Biometric
Reader or remove the Smart Card.
-
Place your finger on the scanning
area of the Biometric Reader.
Retry finger vein authentication.
Disconnect the Biometric Reader
from PC and connect again.
JC26AAJ
Lot Number (7 digit)
0000001
Manufacturing Number (7 digit)
4 / 12