DeWalt DXFRS800 Owner's Manual page 8

Set CTCSS Privacy Codes
To select a CTCSS privacy code:
Mode Button
1. After selecting a channel, press the Mode button until
the CTCSS icon appears and the small numbers next
to the channel number ash on the display.
If DCS is turned on at the channel selected, the
Privacy Code
display will flash the CTCSS icon and "OFF."
To switch from DCS to CTCSS, press the Up or
Down button while the display is ashing
"OFF." The display will then show the small
Up/Down Button
numbers ashing and you will then be able to
proceed to step 2.
2. Press the Up or Down button to select a privacy code.
You can hold the Up or Down button for fast advance.
3. When your desired CTCSS privacy code is displayed, choose one of the
following:
a. Press the Mode button to enter the new setting and proceed to other
functions.
b. Press the Talk button to return to Standby mode.
c. Do not press any buttons for 6 seconds to return to Standby mode.
9
Set DCS Privacy Codes
To select a DCS privacy code:
Mode Button
1. After selecting a channel, press the Mode button until
the DCS icon appears and the small numbers ash on
the display (00 through 83).
DCS Privacy Code
If CTCSS is turned on at the channel
selected, the display will ash the DCS
icon and "OFF." To switch from CTCSS to
DCS, press the Up or Down button while
Up/Down Button the display is flashing "OFF." The display
will then show the small numbers ashing
and you will then be able to proceed to
step 2.
2. Press the Up or Down button to select a DCS privacy code. You can hold
the Up or Down button for fast advance.
3. When DCS privacy code is displayed, choose one of the following:
a. Press the Mode button to enter the new setting and proceed to other
functions.
b. Press the Talk button to return to Standby mode.
c. Do not press any buttons for 6 seconds to enter the new settings and
to return to Standby mode.
To successfully communicate using a privacy code, both
the sending and receiving radios must be tuned to the same
channel and to the same privacy code system (CTCSS or DCS)
and privacy code number. Each channel will remember the
last privacy code system and number you select.
The privacy code 00 is not a privacy code, but allows all
signals to be heard on a channel that is set to 00 on both
the CTCSS and DCS systems.
10