Fence Locks And Stops; Getting To Know Your Jointer-Planer; Product Views; Depth Of Cut Handwheel - Craftsman 113 Owner's Manual

i! !
FENCE
2
;E SLIDING GUA RD
OUTFEEDTABLE /KNOB
INFEED
TABLE
/,
SLIDE
8RACKET
,\\
\
4 CUTTER GUARD 6 ON-OFF
SWITCH
1, DEPTH OF CUT HANDWHEEL. Turning the
handwheel counterclockwise will lower the infeed
table to maximum depth Of !/8,.in,
\
DEPTH OF CUT
HANDWHEEL
i ,, i i1,1
INFEED _ DEPTH OF CUT
TABLE / /J HANDWHEEL
DOWN
2_
FENCE LOCKS AND STOPS. The fence can be
moved acrossthe Jointer to take full advantage of the
"sharpness" of the blades.
The fence should be positioned to the extreme right
(toward pulley) but not beyond the end of the blades.
PUSH DOWN
WHEN LOCKING
FENCE LOCK KNOB
Most of the cutting [usually jointing) will be done with FENCE
the fence in this position. As the blades become dull,
the fence can be moved toward the left where the 45°FENCE
blades are sharper, STOP
SLIDING GUARD KNOB
To move the fence, loosen the Fence Lock Knob and
the Sliding Guard Knob and slide to desired position.
Make sure SLIDE BRACKET is even with surface of
OUTFEE D TABLE. tf it is above or below the surface,
loosen screws and adjust it,
a, Always tighten fence lock knob first to align fence,
then tighten s_iding guard knob.
90 ° FENCE
STOP
FENCE LOCK
KNOB \
\
SLIDE BRACKET
12