Using The Accessories - AEG BSE574221M User Manual

At the set END time the signal sounds
for 2 minutes.
in the display. The oven turns off.
5. Press any button or open the oven
door to stop the signal.
6. Turn the knobs to the off position.
7.6 Setting the MINUTE
MINDER
Minute minder can be both set when the
oven is turned on and off.
1. Press
"00" flash in the display.
2. Press
and than the minutes.

8. USING THE ACCESSORIES

WARNING!
Refer to Safety chapters.
8.1 Using the core
temperature sensor
The core temperature sensor measures
the core temperature of the meat. When
the meat is at the set temperature, the
oven turns off.
There are two temperatures to be set:
• The oven temperature. Refer to the
table for roasting.
• The core temperature. Refer to the
table for the core temperature sensor.
CAUTION!
Only use the core
temperature sensor supplied
with the oven, or genuine
replacement parts.
1. Set the oven function and the oven
temperature.
2. Put the point of the core temperature
sensor (with the symbol
handle) into the centre of the meat.
3. Put the plug of the core temperature
sensor into the socket on the top of
and time setting flash
again and again until
or to set the seconds
When the time you set is longer than
60 minutes,
3. Set the hours.
4. The MINUTE MINDER starts
automatically after 5 seconds.
After 90% of the set time the signal
sounds.
5. When the set time ends the signal
sounds for 2 minutes. "00:00" and
flash in the display. Press any
button to stop the signal.
7.7 COUNT UP TIMER
and
To reset the Count Up Timer, press and
hold
up again.
the cavity.
Make sure that the core temperature
sensor stays in the meat and in the
socket during the cooking.
When you use the core temperature
sensor for the first time, the default
core temperature is 60 °C. While
flashes, you can use the knob for the
temperature to change the default
core temperature.
The display shows the symbol of the core
temperature sensor and the default core
temperature.
on the 4. Press
temperature, or wait 10 seconds for
the setting to be saved automatically.
The new default core temperature is
displayed during the next use of the core
temperature sensor.
flash in the display.
and . The timer starts to count
to save the new core
ENGLISH 13