Installation - Craftsman 124.58833 Operator's Manual

Figure 31 Set Screws
NOTE: The tension of the latch operation for both the Blade
Guard and Pawl Set is pre-set at the factorty. Adjustment (if
needed) can be done by loosening or tightening the 10mm
nylon locking nut on the opposite side of each latch.
INSTALL MITER GAUGE AND PUSH STICK
Refer to Figures 32 and 33.
• The miter gauge comes preassembled. Unpack the miter
gauge and clean thoroughly. Insert into storage slots on
right side of cabinet.
• Insert the push stick into brackets on left side of base.
Figure 33
Push Stick
Latches
Miter Gauge
Figure 32
INSTALL RIP FENCE
Refer to Figure 34.
• Position rip fence assembly at end of saw. Be certain
locking lever is in UP unlocked position.
• Place rip fence assembly onto rails, positioning clamp over
rear rail and then placing rip fence onto front guide rail.
• Rip fence should now ride freely on rip fence rails. Once
rip fence is completely installed, it should be parallel with
the miter gauge and perpendicular to the table. If not, refer
to "Rip Fence Adjustment" found on pages 16 and 17 in the
Operation section of this manual.
Figure 34
GROUNDING INSTRUCTIONS
WARNING: Improper connection of equipment grounding
conductor can result in the risk of electrical shock. Equip-
ment should be grounded while in use to protect operator
from electrical shock.
• Check with a qualified electrician if grounding instructions
are not understood or if in doubt as to whether the tool is
properly grounded.
• This tool is equipped with an approved 3-conductor cord
rated at 300V and a 3-prong grounding type plug
(see Figure 35) for your protection against shock hazards.
• Grounding plug should be plugged directly into a properly
installed and grounded 3- prong grounding-type receptacle,
as shown (Figure 35).
Properly Grounded Outlet
Grounding Prong
3-Prong Plug
Figure 35
CONTINUED ON PAGE 14
13

INSTALLATION