Table of Contents
Advertisement
Introduction
Cordless handset specifications
Frequency
Dimensions
Weight
Battery
Power consumption
Initial charging
Battery life
Battery life in standby
mode
As a part of our policy of continuous improvement, SHARP reserves the right to make design
and specification changes for product improvement without prior notice. The performance
specification figures indicated are nominal values of production units. There may be some
deviations from these values in individual units.
Important safety information
Do not disassemble this product or attempt any procedures not described in this manual. Refer
all servicing to qualified service personnel.
Do not install or use the equipment near water, or when you are wet. For example, do not use
the equipment near a bath tub, wash bowl, kitchen sink or laundry tub, in a wet basement, or
near a swimming pool. Take care not to spill any liquids on the equipment.
Welcome, and thank you for
choosing a SHARP HZT2202B
cordless handset! The HZT2202B
allows you to make both analog
and digital phone calls
2.4 GHz (2.405 to 2.475 GHz)
Width: 1.8" (46 mm)
Depth: 1.7" (42 mm)
Height: 7.1" (180 mm) (not including antenna)
Approx. 0.3 lbs. (115 g) (without battery)
3.6 V Ni-MH battery; capacity: 850 mAh
Approx. 1.0 W (in standby mode)
Approx. 10 hours for initial charge
Approx. 4 hours (240 minutes) (at room temp.)
Approx. 3 days with one full charge (at room
temperature)
Battery life (both normal and in standby mode)
may vary depending on usage, range from
base machine, and environmental conditions
such as temperature.
1
Advertisement
Table of Contents
