Using Balance Adjustment; Adjusting Source Levels - Pioneer DEQ-P7650 Operation Manual

Section
03 Digital Signal Processor
1 Press AUDIO to select POSI.
Press AUDIO until POSI appears in the dis-
play.
2 Press c/d/a/b to select a listening po-
sition.
Press one of these, c/d/a/b, to select a lis-
tening position as listed in the table.
Button Display
c F/L
d F/R
a FRT
b ALL
# To cancel the selected listening position,
press the same button again.
Note
When you make adjustments for listening posi-
tion, the speakers are automatically set for appro-
priate output levels. You can tailor them if you
want as discussed under the heading of Adjust-
ing the speaker output levels using a test tone or
Adjusting the speaker output levels.

Using balance adjustment

You can select a fader/balance setting that
provides an ideal listening environment in all
occupied seats.
1 Press AUDIO to select FAD.
Press AUDIO until FAD appears in the display.
# If the balance setting has been previously ad-
justed, BAL will be displayed.
2 Press a or b to adjust front/rear speak-
er balance.
Each press of a or b moves the front/rear
speaker balance towards the front or the rear.
8
En
All manuals and user guides at all-guides.com
Position
Front seat left
Front seat right
Front seats
All seats
FAD :F25  FAD :R25 is displayed as the front/
rear speaker balance moves from front to rear.
# FAD : 0 is the proper setting when only two
speakers are used.
3 Press c or d to adjust left/right speaker
balance.
When you press c or d, BAL : 0 is displayed.
Each press of c or d moves the left/right
speaker balance towards the left or the right.
BAL :L25  BAL :R25 is displayed as the left/
right speaker balance moves from left to
right.

Adjusting source levels

SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
! Settings are based on the FM tuner volume
level, which remains unchanged.
1 Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
2 Press AUDIO to select SLA.
Press AUDIO until SLA appears in the display.
3 Press a or b to adjust the source vo-
lume.
Each press of a or b increases or decreases
the source volume.
SLA : +4  SLA : 4 is displayed as the source
volume is increased or decreased.
Notes
! The AM tuner volume level can also be ad-
justed with source level adjustments.