Mounting
Install this board in the mainframe of the AV-HS450N or AV-HS450E multi-format
live switcher (hereafter referred as the "AV-HS450").
<Notes>
Be sure to ask the store or dealer where you purchased the product for assistance
with mounting and removal.
Set to OFF and unplug the power connector before mounting and removal.
Before making any physical contact with the board, touch your hand to metal that has
been grounded to discharge static electricity from your body.
An anti-static wrist strap is recommended for safety. Failures may be caused if you
touch this board while you are still charged with static electricity.
Avoid damage to this board by not dropping it or subjecting it to strong shocks or
vibrations.
Be sure to mount the blank panel installed, after removing this board.
When installing or removing this board, take care not to hurt yourself on the edges
and metal parts of the boards.
Turn off the power of the AV-HS450, and unplug the power cord.
Loosen the two screws of SLOT A or SLOT B on the input side at the rear of the
AV-HS450, and remove the blank panel.
Blank panel
Screw
Screw
8 (E)
SLOT A
SLOT B