Copier Trouble; Misfeed Removal - Sharp AL-1551 Operation Manual

6

COPIER TROUBLE?

This chapter describes misfeed removal and troubleshooting.

MISFEED REMOVAL

When the misfeed ( ) indicator blinks or
of a misfeed.
If a misfeed occurs when using the RSPF, a number may appear in the display after a minus
sign. This indicates the number of the originals that must be returned to the document feeder
tray after a misfeed. Return the required number of originals. Then this number will disappear
when copying is resumed or the clear (
When the RSPF misfeeds an original sheet, the copier will stop and the RSPF misfeed ( )
indicator will blink, while the misfeed (
the RSPF, see "E Misfeed in the RSPF" on page 39.
If the copier is turned on with the lower side cover open, the misfeed (
indicator will blink. In this case, close the lower side cover. The misfeed (
indicator will go out.
Ensure that the bypass tray is open and then open the side cover while pressing the
1
side cover open button.
Check the misfeed location. Remove the misfed paper following the instructions for
2
each location in the illustration below.
If blinks in the display, proceed to "A Misfeed in the paper feed area". (p. 36)
If the misfed paper is seen from
this side, proceed to "C Misfeed
in the transport area". (p. 37)
blinks in the display, the copier will stop because
) key is pressed.
) indicator will remain off. For a misfeed of originals in
If paper is misfed here, proceed to "B
Misfeed in the fusing area". (p. 36)
If paper is misfed here, proceed to "A
Misfeed in the paper feed area". (p. 36)
If paper is misfed here, proceed to "D Misfeed in the
lower paper feed area". (p. 38)
)
)
6
35