Brake System Break-In; Pvt Break-In (Clutches / Belt); Standard Break-In; Pre-Ride Inspection - Polaris RZR XP 1000 EPS 2019 Owner's Manual

OPERATION
8. During the break-in period, change both the oil and the filter at 25 hours or
one month.
9. Check fluid levels of transmission and all gearcases after the first 25 hours of
operation and every 100 hours thereafter.

BRAKE SYSTEM BREAK-IN

Apply only moderate braking force for the first 50 stops. Aggressive or overly
forceful braking when the brake system is new could damage brake pads and
rotors.

PVT BREAK-IN (CLUTCHES / BELT)

A proper break-in of the clutches and drive belt will ensure a longer life and
better performance. If a belt fails, always clean any debris from the duct and
from the engine compartment.

STANDARD BREAK-IN

Drive at slower speeds for the first 50 miles (80 km) of operation. Carry only light
loads. Avoid aggressive acceleration, high-speed operation and prolonged
operation at a specific RPM during this period.
SAND / DUNE / MUD BREAK-IN
Drive in low gear for the first 5 miles (8 km) of operation. Avoid prolonged low
speed operation at high throttle. Avoid aggressive acceleration, high-speed
operation and prolonged operation at a specific RPM during this period.

PRE-RIDE INSPECTION

Failure to inspect and verify that the vehicle is in safe operating condition before
operating increases the risk of an accident. Always inspect the vehicle before
each use to make sure it's in safe operating condition.
ITEM
Brake system/pedal
travel
Brake fluid
Front suspension
Rear suspension
Steering
Tires
Wheels/fasteners
60
REMARKS
Ensure proper operation
Ensure proper level
Inspect, lubricate if necessary
Inspect, lubricate if necessary
Ensure free operation
Inspect condition and pressure
Inspect, ensure fastener tightness
REF
page 46
page 140
page 141
page 115
page 115
page 149
page 18
page 145
page 146