Cabinet Cutout Dimensions - KitchenAid 780-0016 Installation Instructions And Use & Care Manual

Outdoor vertical drawers

Table of Contents

Available languages

The illustration below includes cutout dimensions and minimum spacing requirements. The illustration is for reference. The design

of your cabinet layout can be personalized, but the dimensions for the cutouts and minimum spacing must be followed.

Center or support surfaces must be level.

Built-in Outdoor Grill Enclosure Ventilation Requirements

Any outdoor grill enclosure is to be ventilated by openings at

both the top and lower levels of the enclosure. The following

information is the minimum for proper ventilation of your island

construction.



There should be a minimum of 1 7/8" (4.4 cm) of

clearance from the bottom of the main burner bowl

assembly island for proper ventilation.

NOTE: There should be no solid surface underneath the

firebox portion of the grill.

A minimum of 3" (7.6 cm) is required between the back



of the grill and any noncombustible materials. A minimum

of 36" (92 cm) is required between the back of the grill

and any combustible material.

The island must be vented in one of the 2 following ways:



A 90°or a 180°ventilation in the island to ensure that air

flows through the island at either 90°or 180°.

Any enclosure for built-in installation is to have at least



one ventilation opening on an exposed exterior side

located within 2½" (6.0 cm) of the top and is to be a

minimum of 20 in.

(129.0 cm

within 1½" (3.0 cm) of the bottom of the enclosure, and

the bottom opening is to be a minimum of 10 in.

). All vent openings a re to be unobstructed. Every

opening is to be a minimum of 1/8" (0.32 cm) wide.

To ensure that the grill operates properly, it is



recommended that the island have ventilation on all 4

sides as shown in the following illustration. The ventilation

holes should be as diagrammed to ensure adequate

ventilation for your grill and island.