Preparation For Use - Sharp CD-BA120 Operation Manual

PREPARATION FOR USE

1 2 3
FM antenna
Right speaker
Red
Black
1 2 3
AM loop
antenna
Left speaker
Connect each speaker wire to the SPEAKER terminals as shown.
Use speakers with an impedance of 8 ohms or more, as lower
impedance speakers can damage the unit.
Red
Caution:
Black
Note:
Unplug the AC power cord from the AC outlet before con-
necting or disconnecting any component.
Antenna connection
Connect the antenna wire to the ANTENNA jack.
FM antenna
Position the FM antenna wire in the direction where the strongest
signal can be received.
AM loop antenna
Position the AM loop antenna for optimum reception.
Place the AM loop antenna on a shelf, etc., or attach it to a
stand or wall with screws (not supplied).
Notes:
Do not place the antenna on the main unit as it may result in
noise pickup from the internal digital electronics.
Place the antenna away from the unit for better reception.
If the AM loop antenna and the FM antenna wire are placed
near the AC power cord, interference may result.
Do not connect the attached FM antenna to an outdoor FM
antenna. Otherwise, trouble may occur.
Speaker connection
Connect the black wire to the minus ( ) terminal, and the red
wire to the plus (+) terminal.
Do not mistake the right channel for the left channel when
connecting the speakers to the unit.
The right speaker is the one on the right side when you are
facing the front of the unit.
Do not let the bare speaker wires touch each other as this
may damage the amplifier and/or speakers.
Do not allow any objects to fall into or to be placed in the bass
reflex ducts.
Do not stand or sit on the speakers. If the speakers fall or
collapse, you may be injured.
The speaker grille is not removable.
4