Troubleshooting; Service And Repairs; Led Is Blinking; Led Does Not Turn On - DeWalt DW0100 User Manual

Troubleshooting

E
The

LED is Blinking

The battery power is low.
• Check the AAA batteries to make sure:
• Each battery is installed correctly, according to (+) and (–)
listed inside the battery compartment.
• The battery contacts are clean and free of rust or
corrosion.
• The batteries are new, high-quality batteries to reduce the
chance of battery leakage.
• Make sure the AAA batteries are in proper working condition.
If in doubt, try installing new batteries.
The

LED does not Turn On

There is no battery power.
• Install two new, high-quality, name-brand AAA batteries
in the stud sensor.
• Make sure each battery is installed correctly, according to
(+) and (–) listed inside the battery compartment.
The Stud Sensor is not Finding Studs
• Make sure the batteries are working.
• Make sure you have placed the stud sensor on a wall
made of drywall or another common building material.
The stud sensor will not work on walls made of concrete,
mortar, block, brick work, plaster, carpeting, foil- faced
materials, metallic surfaces, or ceramic tile.
• Make sure you have placed the stud sensor flat against
the wall, the stud sensor is in a vertical position (parallel
to a door or window), and you are pressing and holding
the center button as you move the stud sensor SLOWLY
against the wall.
• Make sure the wall is not too thick. DW0100 can be used
on walls < .75" (19mm) thick and DW0150 can be used
on walls < 1.5" (38mm) thick.
• Make sure the wall has a smooth surface.
• Make sure the temperature is within the specified
Operating Range and Relative Humidity.
8

Service and Repairs

Note: Disassembling the tool will void all warranties on the
product.
To assure product SAFETY and RELIABILITY, repairs,
maintenance and adjustment should be performed by
authorized service centers. Service or maintenance performed
by unqualified personnel may result in a risk of injury. To
locate your nearest D WALT service center, go to http://www.
E
D WALT.com.
E
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to faulty
E
materials or workmanship for three years from the date of purchase.
This warranty does not cover part failure due to normal wear or
tool abuse. For further detail of warranty coverage and warranty
repair information, visit www.D
(1–800–433–9258). This warranty does not apply to accessories or
damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may
have other rights which vary in certain states or provinces.
In addition to the warranty, D WALT
E
1 YEAR FREE SERVICE
D WALT will maintain the tool and replace worn parts caused by
E
normal use, for free, any time during the first year after purchase.
90 DAY MONEY BACK GUARANTEE
If you are not completely satisfied with the performance of your
D WALT Power Tool, Laser, or Nailer for any reason, you can return
E
it within 90 days from the date of purchase with a receipt for a full
refund - no questions asked.
RECONDITIONED PRODUCT: Reconditioned product is covered
under the 1 Year Free Service Warranty. The 90 Day Money Back
Guarantee and the Three Year Limited Warranty do not apply to
reconditioned product.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-D
local service center for a free replacement.
WALT.com or call 1–800–4-D
E
tools are covered by our:
®
WALT or visit your
E
WALT
E