Properties - Siemens CP 1625 Operating Instructions Manual

Product overview
2.4 Communications processor CP 1625Dev
2.4.2

Properties

The CP 1625 is a PCIe module for the connection of PCs to Industrial Ethernet.
Note
The PROFINET ports must not be connected directly to the Internet.
The essential properties are as follows:
● Optimized for PROFINET IRT
● With Ethernet-Real-Time-ASIC SOC-1
● Two RJ45 sockets for connecting end devices or other network components
● Front LEDs on the RJ45 sockets for efficient self-diagnostics of connection and data
exchange (Link and Activity LED)
● Integrated 2-port real-time switch
● Automatic hardware detection is supported
● 24 V DC power supply for operation outside of the PC housing
● Two UART interfaces are available over the header
● Pushbutton for manually restarting the board
● Two LEDs on the board that signal an error or maintenance (Error and Maintenance LED)
● NAND flash
● SYNC Out signal available via the solder joint
● DDR2 memory technology up to 256 MB RAM
External power supply
The CP 1625Dev has the "X80" interface for infeed of an external 24 V DC power supply.
Note
Only for stand-alone operation outside an IPC.
Ethernet
The CP 1625Dev is intended for operation in Ethernet networks.
It also has the following features:
● Connections are designed for 100BASE-TX
● Data transmission speed of 100 Mbps in full/half duplex is supported
● Autonegotiation (can also be turned off)
● Autocrossing
18
CP 1625 / CP 1625Dev
Operating Instructions, 04/2018, A5E43075902-AA