Table of Contents
Advertisement
Item number Item name
903
FREEZE MODE
904
FREEZE CONTROL
FROM KEY PANEL
905
AUTO FREEZE
CONTROL
906
STOP FREEZE
CONTROL
SDTI-CP OUTPUT BIT
914
RATE (only when the
BKNW-124 is installed)
915
SDTI-CP OUTPUT
FORWARD ERROR
CORRECTION (only when
the BKNW-124 is
installed)
6-3-2 Extended Menu Operations
In the extended menu, you can carry out the same
operations as in the basic menu.
For details of basic menu operation, see Section 6-2-2,
"Basic Menu Operations" (page 6-4).
Note
To access the extended menu, a setting on the internal
SS-83 board is required.
For details, refer to the Maintenance Manual (Part 1).
Menu items in the 900s, relating to digital processing
Settings
Select the freeze mode and timing.
FIELD : Freeze a video field. Field may be odd or even, according to the timing.
FLD1: Freeze an odd field.
FLD2: Freeze an even field.
FRM12: Freeze a frame consisting of an odd field and following even field.
FRM21: Freeze a frame consisting of an even field and following odd field.
Odd and even fields are distinguished by the reference video signal.
Changing the menu setting during a freeze does not affect the freeze image.
The setting is reflected the next time a freeze is carried out.
Select the control panel operation for a freeze.
MOMNT : A freeze is carried out while the button is held down.
LATCH: When the button is pressed, a freeze is carried out, and this state is
maintained when the button is released. During a freeze, if the same operation
is repeated the freeze image is updated.
The operation is as follows.
• Press the DELETE button and TRIM + button on the control panel
simultaneously to carry out a freeze.
• Press the DELETE button and TRIM – button on the control panel
simultaneously to end the freeze.
Item 903 determines the details of a freeze.
Set the auto freeze function operation (conditions for ending a freeze, etc.).
During normal playback of a Betacam SX cassette tape, if there is a sudden
change of the channel condition (unrecordable signals), this function freezes the
image.
DIS : Disable the auto freeze function.
MODE1: End the freeze when signals which can be recorded normally are
restored.
MODE2: End freeze automatically on playback after stopping.
• The automatic freeze mode is determined by item 903.
• The freeze is ended immediately, regardless of the above conditions, when this
unit is switched to cue-up mode.
Select whether or not the STOP FREEZE function should operate.
DIS : Does not operate.
ENA: Operates.
Specify the bit rate of the MPEG stream within the SDTI-CP output signal.
50I : 50 Mbps
40I : 40 Mbps
30I : 30 Mbps
Specify whether or not the FEC (Forward Error Correction) is added to the SDTI-
CP output signal.
ON : The FEC is added.
OFF : The FEC is not added.
6-19
Chapter 6 Menu System
Advertisement
Table of Contents
