Activating/Deactivating The Handset - Siemens Gigaset Gigaset S1 Operating Manual

Conducting calls – the basic functions
Step by Step
2

Activating/deactivating the handset

a
Press the On-hook key until the activation or deactiva-
tion is confirmed by a crescendo tone sequence.
Note:
• The handset can only be fully switched off
when removed from the charging shell.
• After switching off a mobile phone, place it in
the charging shell; with PIN "0000" it will
switch on immediately and is ready for ope-
ration. If the PIN is not "0000", you must first
enter the PIN. Only then is the mobile phone
ready for operation.
• When a handset that is ready for operation is
placed in the charging shell it goes to idle sta-
tus and shows the idle display.
If your preferred language for the display texts is not
set, you can set this yourself (
If a mobile phone that is switched off is placed in the
charging shell, it will switch on.
If the PIN is still the same as the factory default (0000),
the phone is ready for operation.
If the PIN is not the same as the factory default, the PIN
must be entered to make the mobile phone ready for
operation.
Displaying the connection quality
The strength of the incoming signal is displayed by the
"receive field strength" icon in on or message status:
|
No receive field strength
Ò
Low receive field strength
Ñ
50% receive field strength
Ð
100% receive field strength
The radio range is different indoors and outdoors
( page 97). Please consult your system administrator
in the event of range problems.
page 16).