Call Setup - Siemens M75 User Manual

82 Setup

Call setup

¢ ¢
Call setup
C
T
¢
Select function.
Hide ID
When you make a call, your phone
number can be displayed on the re-
cipient's display (depending on the
service providers).
To suppress this display, you can
enable the "Hide ID" mode for all sub-
sequent calls or just for the next call.
You may need to register separately
with your service provider for these
functions.
Call waiting
If you are registered for this service,
you can check whether it is set and
you can activate/deactivate it.
Divert
You can specify the conditions under
which calls should be diverted to
your mailbox or other numbers.
Status check
You can check the current divert
status for all conditions. After a
short pause, the current situation
is transmitted by the network and
displayed.
Ö
Õ
Ô
b
Clear all
All set diversions are cleared.
Set up call divert (example)
The most common condition for call
divert is, for example:
Unanswered
I
b
C
Set
C
/
Ï
J
§OK§
Condition set.
Not set.
Display if status is un-
known (e.g. with a new
SIM card).
Select Unanswered.
(Includes the conditions
Not reachable, No
Busy, see below.)
Confirm.
Select.
Confirm.
Select or enter the phone
number to which the calls
are to be diverted.
Use existing mail-
§Mailbox§
box phone numbers, or
enter them if necessary.
Confirm. After a short
pause, the setting is con-
firmed by the network.
b
b
reply,