Siemens Gigaset 3000 Operating Instructions Manual page 22

Logging handsets onto a telephone system
Open the logon window with the second telephone.
An "Optiset E" Hicom telephone is used here by way of
example to demonstrate the procedure:
e.g. ... Enter the code for activating the code
e.g....
e.g. ... Enter the handset code no. (PIN E1),
e.g.
e.g. ... Confirm the displayed handset
* The display may differ slightly depending on the telephone used as Optiset de-
vices support 24 characters and handsets 16 characters.
Take your handset and log it on to the system
(see page 23).
Note:
The logon window is automatically closed if the handset
is not logged on as described above within 10 minutes. In
this case, you must repeat the procedure.
no. e.g. " 24".
An input prompt appears.
Enter the assigned handset call
number, e.g. "45678".
For network-wide code no.: terminate
code no. with "#".
An input prompt appears.
for example, "13579".
Stars are displayed instead of dig-
its.
For network-wide code no.: terminate
code no. with "#".
The handset call number is displayed.
number by re-entering it, e.g. "45678".
Do not terminate with "#".
The ring tone sounds briefly. The log-
on window opens for 10 minutes when
the ring tone is no longer audible.
22
*