Philips Selecon Accent LED Beamshaper Operation Manual

Download this manual

Philips Selecon Accent LED Beamshaper

**OPERATION MANUAL**

THIS INFORMATION IS DESIGNED TO PROVIDE YOU WITH THE INFORMATION

YOU NEED IMMEDIATELY UPON DELIVERY OF YOUR NEW LUMINAIRE.

If you require further assistance please contact your Philips Selecon dealer. www.seleconlight.com/distributors

Philips Selecon has packaged this product using environmentally friendly packaging. Please consider either

reuse of the packaging or dispose of responsibly with your nearest recycling collection agency.

IMPORTANT!

Read this manual carefully before attempting to install, operate or maintain the Accent LED Beamshaper. Follow the

instructions in this manual. Philips Selecon accepts no responsibility if the customer fails to do so.

For each customer, operating conditions will vary, sometimes greatly. Such variations may affect the luminaire's

performance. Philips Selecon has no control over the customer's unique operating environment. Hence, Philips Selecon

makes no representations or warranties concerning the luminaire's performance under the customer's actual operating

conditions. All operating parameters must be validated for each customer application by the customer's technical experts

Safety Warnings

Not for residential use. Maximum ambient temperature 25°C

CAUTION: Hot surfaces - avoid contact by persons or materials.

The Accent LED Beam Shaper has some hot surfaces. Be careful to avoid burns. We suggest the use of leather

gloves when focusing these luminaires.

SAFETY – Risk of Electric Shock: Always electrically isolate from mains power before cleaning or servicing.

CAUTION: Replace the lenses if they have become visibly damaged to such an extent that their effectiveness has

become impaired, for example by cracks or deep scratches.

These fixtures are not suitable for outdoor use. They are rated at IP20.

The fixture should be at least 2.6 feet /0.8 metres away from the nearest object it is lighting.

.8 0.8M

= 90

The Accent range can be operated only through a range of angles 90 either side of horizontal.

WARRANTY REGISTRATION:

Take full advantage of the Philips Selecon service commitment and register all

your new luminaires quickly and easily online for full after-sales support.

FEB 2015

www.seleconlight.com/warrantyreg

Page 1 Read this manual carefully before attempting to install, operate or maintain the Accent LED Beamshaper. Follow the instructions in this manual. Philips Selecon accepts no responsibility if the customer fails to do so. For each customer, operating conditions will vary, sometimes greatly. Such variations may affect the luminaire’s performance.
Page 2 Finger tight pressure only is necessary to lock the lens off in its chosen position. The four shutters can be used to mask off portions of the beam, or to frame areas, etc. FEB 2015 © 2015 Philips Selecon All Rights Reserved...
Page 3 SAFETY AND MAINTENANCE Keep your Philips Selecon Accent LED Beamshaper in top condition and performing at its best by cleaning it regularly with a soft cloth. The Beamshaper lenses should only be cleaned with optical tissue paper. The above is the only maintenance task that can be safely carried out by non approved personnel.
Page 4 Selecon does not wish to service, repair or replace the defective luminaire, it shall refund the purchase price. Philips Selecon’s sole responsibility is to repair, replace or service a luminaire subject to a valid warranty claim. Under no circumstance will Philips Selecon be liable for direct, indirect, incidental, special or consequential costs or damages, including dismantling and re-installation costs, loss of operations or profits, to the maximum extent permitted by law.