Advertisement
Keys instruction
First to dial down the toggle switch so that the controller is in normal remote-control mode
1 . ① key is group 1, press it to control those lamps in the group
2 . ② key is group 2, press it to control those lamps in the group
3 . ③ key is group 3, press it to control those lamps in the group
4 . ④ key is tunable white, press it to switch 2700k --3500K-4000K-5000K-6000K on the lamp
5 . ⑤ key is RGBW, press it to switch red-green-blue-cyan-Purple on the lamp
6 . ⑥ key is On/Off keys, press it to control the lamp
7 . ⑦ key is Is dim up, keep pressing the key to dim up gradually. When luminaire is turned off,
it will light up automatically
8 .
⑧
key is Dim down,, keep pressing the key to Dim down gradually. It will turn on when the state
is off at the lamp
Dial up the toggle switch on the back, press 6 key until the LED is flicker under the ⑥ key, which means the remote controller has
been restored to original state
Accessing Zigbee mesh network
1 . Searching and adding new equipment in APP , Gateway open the Zigbee mesh network
2 . Turning the ① key slide switch on the back to the up, press ⑤ key on the front of remote and then the LED will flicker and
the remote search network. The LEDs will go out immediately after flashed six times. It mean the equipment is into
the mesh network
Control
Turn the slide switch downward on the back first
Press ①、② and ③ keys which are equipment group and then LED under button will brighten up for a second.
Press ④、⑤、⑥、⑦ and ⑧ keys to control equipment and dimming amp
Product configuration
01 Add Product
02 Select One Option
03 scan
05 Input MAC CODE
04 Search
07 Successful Adding
New product can be located after
Network overtime or searching failure
successful adding
warning,please check again
06 Select Zone
08 Adding Failure
Check Gateway and
enviromnent
1
compatibility
Check product power-on condition
2
Retry after few seconds
3
Advertisement
