5. Device LED constellation will blink, indicating that device is in pairing mode. Device is
on pairing mode 60 seconds at the time.
6. You should see "VR CONTROLLER ‐ Left" or "VR CONTROLLER ‐ Right" appear in the
Bluetooth menu.
7. Select "Connect", device will make single vibrate when connected. Windows Bluetooth
settings should indicate state as 'Connected'.
8. Replace the battery cover.
9. Repeat these steps to pair the other VR CONTROLLER.
Device can be bonded with single host PC at the time.
You can un‐pair device by removing controller from Windows Bluetooth setting or setting the device
again into pairing mode.
RECONNECTING AFTER FIRST PAIRING
After device has been successfully paired with host, it will reconnect next time when powered
on.
POWERING OFF CONTROLLER
Press Windows button for 4 seconds to power off the controller. The device will vibrate twice
and the LEDs will turn off.
If device is not tracked or it is motionless 30 seconds, controller will move to low power state to
save power, picking up controller or pressing button will wake up the device.
Your device will also automatically power off if there has not been motion for 10 minutes.
DEVICE INDICATORS
VR CONTROLLER uses LED constellation ring and haptics for indicating about its state.
Activity
Power on/off
Idle
Pairing
Connect/Disconnect
Low Battery Level
Trigger
Windows button press
Controller not tracked by HMD or
motionless for 30 seconds
Pairing button press
Controller connected or disconnected
to/from host PC
During power on when battery level
is "Low"
Indication
LED goes on/off and device vibrates 2 times
Light blink slowly every 3 seconds to indicate
the device is in idle mode
Lights slowly pulse when the device is in
pairing mode
Device vibrates once
Lights blink twice when the device is turned
on
4