ABB Totalflow microFLO G4 Startup Manual page 10

Pin
Pin 1 VBATT
Pin 2 Ground (GND)
Pin 3 Switched (SW VBATT)
Pin 4 Operate (OPER)
Pin 5 N/A
Pin 6 Request to Send (RTS)
Pin 7 Transmit Data (TXD)
Pin 8 Receive Data (RXD)
Pin 9 Clear to Send (CTS)
Step 9 PCCU32 Configuration
The following information details the steps necessary for the user to set
up the parameters within PCCU32.
9A Connect the laptop running PCCU32 to the unit. Start
PCCU32. Upon completion, move into Entry mode. The user
will need to establish the following minimum required entries in
the Station Setup tab:
•
•
•
Note: There are additional fields stored in WinCCU for uniquely
identifying the meter, including fields for entering the lease
holder, producer, operator and buyer. These fields reside on the
host computer and not the µFLO
•
8
Table 1 Com1 J10
RS-232
VBATT
Ground (GND)
Switched (SW VBATT)
Operate (OPER)
Remote Request to Send
(RRTS)
Transmit Bus – (TBUS -)
N/A
N/A
Station ID – The station identifier should uniquely
identify one station from that of others.
Device ID/Application ID – On a µFLO
code should uniquely identify one µFLO
others and will be the same as the Station ID.
Location – The host software, WinCCU, has a Location
field that can hold up to 24 alphanumeric characters
used to describe it. An example would be the country
name or road number.
Date/Time – The µFLO
before other tube parameters are entered. This ensures
that events are properly dated and time tagged. The
G4
µFLO date and time must be set correctly and should
agree with the collection equipment. PCCU32 or
WinCCU can be used to update the date and time of
the device.
RS-485
Transmit Bus + (TBUS +)
G4
.
G4
date and time should be set
RS-422
VBATT
Ground (GND)
Switched (SW VBATT)
Operate (OPER)
Remote Request to Send
(RRTS)
Transmit Bus + (TBUS +)
Transmit Bus – (TBUS -)
Receive Bus + (RBUS +)
Receive Bus - (RBUS -)
G4
, the identifier
G4
from that of