Selecting The Illumination Color; Setting The Rear Output And Subwoofer Controller - Pioneer DEH-P6800MP Operation Manual

Initial Settings
2 Press c or d to adjust the brightness
level.
Each press of c or d increases or decreases
the brightness level. 0  15 is displayed as the
level is increased or decreased.
Selecting the illumination
color
This unit is equipped with two illumination col-
ors, green and red. You can select the desired
illumination color.
1 Press FUNCTION to select ILLUMI.
Press FUNCTION repeatedly until ILLUMI ap-
pears in the display.
2 Press c or d to select the desired illumi-
nation color.
Pressing c or d will switch ILLUMI between
red or green and that status will be displayed
(e.g., ILLUMI :GRN).
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (REAR SP :FULL) or subwoofer
(REAR SP :S/W) connection. If you switch the
rear output setting to REAR SP :S/W, you can
connect a rear speaker lead directly to a sub-
woofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (REAR SP :FULL). When rear
output is connected to full range speakers
(when REAR SP :FULL is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controllers (low pass filter,
All manuals and user guides at all-guides.com
phase) built-in PREOUT :S/W or the auxiliary
PREOUT :FULL.
1 Press FUNCTION to select REAR SP.
Press FUNCTION repeatedly until REAR SP ap-
pears in the display.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
REAR SP :FULL (full-range speaker) and
REAR SP :S/W (subwoofer) and that status will
be displayed.
# When no subwoofer is connected to the rear
output, select REAR SP :FULL.
# When a subwoofer is connected to the rear
output, set for subwoofer REAR SP :S/W.
# When the rear output setting is
REAR SP :S/W, you cannot change the subwoofer
controller.
3 Press c or d to switch the subwoofer
output or nonfading output (full-range
RCA output).
Pressing c or d will switch between
PREOUT :S/W and PREOUT :FULL and that
status will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page 43)
or subwoofer output (refer to Using subwoofer
output on page 42) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and nonfading output in the
audio menu return to the factory settings.
! Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.
Section
10
47
En