Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Instruction Manual
Advertisement
Table of Contents
Related Manuals for DeWalt DW300
Summary of Contents for DeWalt DW300
- Page 1 Questions? See us on the World Wide Web at www.dewalt.com INSTRUCTION MANUAL DW300 VS Orbital Jig Saw FINAL PRINT SIZE: 5.5 x 8.5"...
-
Page 3: Definitions: Safety Guidelines
c) Keep children and bystanders away while operating a Definitions: Safety Guidelines power tool. Distractions can cause you to lose control. The definitions below describe the level of severity for each 2) ELECTRICAL SAFETY signal word. Please read the manual and pay attention to these a) Power tool plugs must match the outlet. -
Page 4: Specific Safety Rules
skid safety shoes, hard hat, or hearing protection used for d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or appropriate conditions will reduce personal injuries. these instructions to operate the power tool. Power tools c) Prevent unintentional starting. - Page 5 • Keep hands away from cutting area. Never reach underneath • Air vents often cover moving parts and should be avoided. the material for any reason. Hold front of saw by grasping the Loose clothes, jewelry or long hair can be caught in moving parts. contoured gripping area.
- Page 6 work in a well ventilated area, and work with approved safety BPM ..... beats per minute n ......rated equipment, such as those dust masks that are specially designed to IPM ....impacts per minute ......speed filter out microscopic particles. SPM ..... strokes per minute .....earthing •...
-
Page 7: Operation
DESCRIPTION (FIG. 1) 3. Release the lever. 4. Check to ensure blade is secure before cutting. WARNING: Never modify the power tool or any part of it. Damage or personal injury could result. Adjusting the Shoe for Bevel Cuts A. Trigger switch G. - Page 8 Switching On and Off NOTE: Metal or hardwoods should never be cut in orbital action. To switch the tool on, squeeze the trigger switch (A). TO ADJUST THE CUTTING ACTION For continuous operation, squeeze the trigger switch then depress 1. Move the cutting action lever (I) between the four cutting the lock-on button (B).
-
Page 9: Sawing Metal
Hints for Optimum Use When ripping, position as FIG. 8 shown in Figure 7 and slide SAWING LAMINATES the rip fence under the screw As the saw blade cuts on the upward stroke, splintering may occur from either side of the saw. on the surface closest to the shoe plate. -
Page 10: Protecting The Environment
SPECIFICATIONS Accessories DW300-B3 WARNING: Since accessories, other than those offered by Volts 120V ~ WALT, have not been tested with this product, use of such... -
Page 11: Troubleshooting
TROUBLESHOOTING Problem Possible Cause Possible Solution • Unit will not start. • Cord not plugged in. • Plug tool into a working outlet. • Circuit fuse is blown. • Replace circuit fuse. (If the product repeatedly causes the circuit fuse to blow, discontinue use immediately and have it serviced at a D WALT service center or... - Page 12 R.F.C.: BDE810626-1W7 WALT Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286 (SEP15) Part No. N440832 DW300 Copyright @ 2010, 2015 D WALT The following are trademarks for one or more D WALT power tools: the yellow and black color scheme; the “D” shaped air intake grill; the...