Configuring Interfaces
Table 5: Reason Codes for Interface States
Administrative
Configuration
Up
Down
Up
Note
Only some of the reason are listed in the table.
If the administrative state is up and the operational state is down, the reason code differs based on the
nonoperational reason code, as described in
Operational Status
Reason Code
Up
None.
Down
Administratively down—If you administratively configure an
interface as down, you disable the interface. No traffic is
received or transmitted.
Down
See
Table 6: Reason Codes for Nonoperational States , on page
22. Note that only some of the reason codes are listed in
6: Reason Codes for Nonoperational States , on page
Table 6: Reason Codes for Nonoperational States , on page
Cisco MDS 9000 Series Interfaces Configuration Guide, Release 8.x
Reason Codes
Table
22.
22.
21