Table of Contents
Advertisement
3.
Move the tray to the desired angle by pulling it up or down.
4.
Release the knob when the tray is at the desired angle.
Tips for a successful batch scan
The angle of the output tray should be adjusted so that the scanned sheets of paper fall freely from the scanner
to the tray without jamming. The stoppers should be previously set up.
The best angle for the tray could vary slightly with the paper type, the paper size, and the ambient conditions
(temperature and humidity).
There could be some variation in the angle from the first page to the subsequent pages, due to the different
friction coefficient paper/tray versus paper/paper. You are strongly recommended to set the angle with a sheet
of paper in the tray.
1.
If the end of a sheet is trapped in the scanner and does not slide completely into the tray, the angle of the
tray should be changed, lowering the height of the end of the tray.
ENWW
Tips for a successful batch scan
7
Advertisement
Table of Contents
