Fixture Setup - Philips ColourChaser Touch Installation Manual

12 Philips ColourChaser Touch Manual

Fixture setup

Before first use, and whenever changes are made to the lighting
installation, the controller must be configured with the number and
types of connected fixtures.
Configure the controller as follows.
1 If you have not already done so, install the ColourChaser Designer
software.
2 Start ColourChaser Designer.
3 Connect the ColourChaser Touch to any USB port on the computer
using the included USB cable. Do not connect the controller to the PC
before the software is installed.
4 Within a few seconds, the computer detects the controller and asks
whether you want to load data from the device. Click Yes.
5 The next prompt alerts you that loading data will cause any unsaved
changes to be lost.
Click Yes to continue.