Standard Series Specifications (Rack Mounted) - Toshiba 1400SE Series Operation Manual

TOSHIBA
4.0 Specifications
4.3

Standard Series Specifications (Rack mounted)

Input
Battery
Battery backup time when fully charged
with 0.7 power factor at 77° F (25° C)
Output
Output voltage regulation
Output voltage waveform
Rated load power factor
Voltage transient characteristic
Rated output current (rms)
Maximum output current (peak)
Inverter overload capacity
Environment
Switches
Interface
Fault detect and input power loss
Options Software for unattended
(*) Output capacity reduced when input voltage is between -15% and -30% of nominal.
(**) Battery backup time may vary depending on the operating conditions including ambient temperature at the
installation site.
(***) An initial charge time of 24 hrs. is necessary to obtain proper battery performance level before unit is used
for battery backup.
(****) At 6000 ft (2000 m) above sea level, output capacity should be derated by 3%.
MODEL NUMBER UC1A1A015C6RKB
CAPACITY 1500 VA (1.05 kW)
Input voltage Single phase, 120 Vac, +10% to -30% (*)
Input frequency 45 to 65 Hz
Input capacity
Input power factor Approximate unity (0.98 to 1.0)
Battery rated voltage
10 mins. at full load (**)
30 mins. at half load (**)
Recharge time Maximum 24 hrs to 100% (90% recharge after 8 hrs) (***)
Type of batteries Sealed lead-acid
Output voltage Single-phase, 120 volts
Within than +/- 3%, steady state
Output frequency 50/60 Hz +/- 0.5% in free-running mode (line sync range +/- 1Hz)
Computer-grade sine wave with less than 3.0% total harmonic
distortion with linear load
0.7 lagging (0.6 to 1.0)
+/- 5% under 100% load step change
150% for 60 seconds
Crest factor 3.0
Operating temperature 32 to 104° F (0 to 40° C), optimal at 77° F (25° C)
Storage temperature -4 to 104° F (-20 to 40° C)
Operating humidity 30 to 90%, no condensation
Altitude(****) Less than 3000 ft (1000 m) above sea level
Overall dimensions 19W x 20D x 5.25H in (482W x 508D x 133H mm)
Net weight 81 lb (36.8 kg)
Acoustical noise 45 dB at max. output, measured 3.3 ft (1 m) from front panel
Efficiency (ac-dc-ac)
Bypass switch Automatic bypass is provided when the run switch is in the off
position, if a fault occurs, or if an overload occurs (transfer time is
approximately 4 mS)
IBM (TM) AS/400 Pins 5 through 9
LAN Manager Pins 2 and 3
Pins 1 and 4
RS232 ASCII Pins 1 through 8
computer shutdown Contact Toshiba for details on this option
External battery pack Contact Toshiba for details on this option
UC1A1A020C6RKB
2000 VA (1.4 kW)
1500 VA 1920 VA
72 Vdc 72 Vdc
7 mins. at full load (**)
21 mins. at half load (**)
12.5A
37.5A
81 lb (36.8 kg)
87%
DB9 male connector
DB9 female connector (Pin 9 not used)
4 - 6
16.7A
50.0A
87%