Quick Start Guide - DeWalt D24000 Instruction Manual

ENGlIsH

QUICK START GUIDE

D24000 WET TILE SAW

WARNING: For your own safety, read the instruction
manual before operating the wet tile saw. Failure to
heed these warnings may result in personal injury and
serious damage to the saw. When servicing this tool,
use only identical replacement parts. Have damaged
cords replaced by an authorized service center.
The motor arm assembly comes assembled. Open the box
and lift the assembly out, as shown.
STEP 1
1. Install the motor arm onto frame assembly. Using the
wrench supplied, install and tighten the two screws
closest to the rail first. Install and tighten the other
two screws.
34
STEP 2
2. Attach the cutting wheel.
a. Using the smaller hex wrench supplied, loosen (do
not remove) the screw on the side of the cutting
wheel cover. Pull the rubber side flap back and lift the
cover toward the rear of the saw.
b. Press spindle lock button. Remove the cutting wheel
nut with hex wrench provided. Remove outer flange.
c. Install the cutting wheel with the rotational arrow
facing the same way as on the rotational arrow
on the cutting wheel cover. Press the spindle lock
button while tightening the cutting wheel nut.
d. Replace cover and tighten screw.
For further details, refer to To Attach Cutting Wheel in the
Instruction Manual.
STEP 3
3. Attach the cutting cart to the rails.
For further details, refer to Assembly in the
Instruction Manual.
NoTE: Make sure the cart lock is in full open position.
a. Align the arrow on the rear of the cutting cart with
the round rail on the frame of the saw.
b. Place the rear roller assembly onto the round rail.